Loading... Please wait...


facebook.png twitter.png youtube.png youtube.png

Site Updated



Our Newsletter

f16 clearomizer instruction page

The F16 is here! After testing over 1/2 a dozen 'large style' clearomizers, we have settled on the F16 as the one that beats them all. This clearomizer is well built and works absolutely amazingly, with a design that makes it nearly impossible to hit less then perfect, and a nearly impossible to leak tank.

Starting with your F16

Filling up your F16

Filling up the F16 can be tricky at first, but once you get the hang of it it should take you just a minute or two. You can fill a F16 with a standard drip tip e-liquid bottle, but it may be easier for some to use the optional needle tip. (available Here. You should have a paper towel nearby as you fill your F16 to be safe.

  1. Remove the mouthpiece by pulling up on it.
  2. Start by pushing down on the center cartomizer (the tube inside the clearomizer) and then pull down from the bottom, until the cartomizer inside is approximately 1/2 an inch below the rubber seal.
  3. Begin filling e-liquid, letting it slide down the outside edge of the plastic outer walls. Continue to fill until it is just below the level of the cartomizer --- Do not fill inside of the cartomizer.
  4. Carefully slide the cartomizer back up through the top rubber seal, ensuring it is all the way up.
  5. Replace the mouthpiece.
  6. Ensure the cartomizer is pushed all the way up inside of the clearomizer outer shell.
  7. Wipe the threads and clearomizer.

A few things to keep in mind about your F16 clearomizer:

  1. Because of the size of the F16 clearomizer, it is possible for it to roll away from you. Be sure ot set it down safely so it will not roll
  2. When screwing the F16 into a battery, it may be easier to hold it by the mouthpiece, as the outside tubing will twist with the battery.
  3. After filling for the first time, wait a few minutes for the e-liquid to absorb into the cartomizer.
  4. Most people find the most effective way to vape is to take slower and longer draws then you would with a tobacco cigarette.
  5. In the event that e-liquid gets trapped in the airflow holes, you may hear a bubbling sound as you vape. Simply take a piece of paper towel and wrap it around the bottom of the F16 where the airflow holes are located, and blow hard into the mouthpiece several times. This should push the e-liquid out through the air holes and onto the paper towel.